Benefits of microox® Technology

The alloys used for microox® are optimally suited for normal ambient and usage conditions. Their corrosion properties are characterised by an oxide layer that has a protective function in aggressive ambient conditions.
Only in ambiances where chlorides occur in high concentration, the use of aluminium can not be recommended.

microox® heat exchangers are made entirely of aluminium. This makes them up to 50% lighter than conventional fin-tube heat exchangers.

Like all other heat exchangers, microox® heat exchangers have to be cleaned regularly. The low coil depth of 20 mm and the high strength of microox® heat exchangers allow them to be cleaned thoroughly with normal water pressure or with a high-pressure cleaner at pressures up to 50 bar.

microox® heat exchangers require up to 75% less refrigerant than other heat exchangers in relation to their performance.
EU Regulations 842/2006 (fluorinated greenhouse gas regulation) and 1005/2009 specify that leak tests must be carried out in relation to the volume of refrigerant in the system. Consequently, a lower volume can mean fewer leak tests.

Transportation poses major challenges in terms of packaging and device stability. Because of this, extensive load tests have been carried out on microox® heat exchangers in different transportation situations. This ensures the load-bearing capacity of microox® heat exchangers during transportation and also that customers receive the device where it is to be installed in the same quality with which it leaves our factory.